Ice Water Shock Submersion Ingress Protection Test Equipment ISO 16750-4 Clause5.4.3

Ice Water Shock Submersion Ingress Protection Test Equipment ISO 16750-4 Clause5.4.3

  • Model:

Ice Water Shock Submersion Test Equipment

 

 

Standard

The Ice Water Shock Submersion Test Equipment is designed and produced as the standard of the ISO 16750-4:2010 5.4.3.

 

Test method

Connect the DUT to the test equipment. Operate the DUT in a hot air oven TMAX

for the specified holding time,t h.With the device still operating, submerge it for 5 min in an ice water tank at lease 10mm deep.

 

Parameter:

 

Studio size100×105×108(D×W×H)cm
Temperature rangeRT+10℃~160℃
Heating rateRT+10℃~160℃≤40min
Test liquid mediumdeionized water or +5%NaCl
Water tank volumeAbout 100L (motor stirring, bottom slope, easy to clean drainage)
Water temperature(0~+4)℃
Cooling rate

In high temperature, the water temperature needs to be stable at 2 °C in 30 minutes, and 160 °C in the test box.

 

Immersion time5min
Holding time ,t h at Tmax

I h or until DUT temperature stabilization is reached.

 

Transition duration< 20s
Test fluidde-ionized water.

 

Introduction to structural design

 

1. The outer casing of the equipment is made of 2mm high-quality galvanized steel plate CNC machine tool, and the surface of the outer casing is sprayed, which is more smooth and beautiful.

2, the liner is SUS316 high-quality stainless steel mirror panel; in order to facilitate the recycling of the test medium and the cleaning after the Zui, the bottom of the equipment studio is designed as a funnel;

3, insulation material: high-density fiberglass cotton to ensure insulation performance, maintain indoor balance and stable temperature;

4. The door is provided with a transparent window for observing the change of the indoor sample, and the observation window is made of multi-layer hollow tempered glass;

5. The mixing system adopts long-axis fan motor and high-low temperature resistant stainless steel multi-wing impeller to achieve vertical convection vertical diffusion cycle, so that the temperature and humidity in the laboratory are uniform and stable;

6. Double-layer high-temperature resistant high-strength sealing strip is used between the door and the cabinet to ensure the sealing of the test area. The inner door material of the door is made of stainless steel, and the door handle is made without reaction, which makes the operation easier;

7. Test hole (left side of the machine) can be used for external test power cable or signal cable (100mm aperture);

8. The refrigeration system of the equipment is installed at the bottom, and the compressor is imported from Taikang brand in France to ensure the cooling effect and reliability.

9. The bottom of the machine is equipped with a high-quality fixed PU movable wheel, which can easily move the machine to the designated position, and fix the caster after the Zui;

10. The control part of the equipment is designed on the right side of the equipment. It is distributed with temperature controller and control switch. It is easy to operate, simple and easy to maintain.

 

Equipment use conditions

 

1. the ambient temperature: 5 ° C ~ +32 ° C;

2. Ambient humidity: ≤85%;

3. power requirements: AC380 (±10%) V / 50HZ three-phase five-wire system;

4.pre-installed capacity: about 11KW


Ingress Protection Test EquipmentIngress Protection Test Equipment

Ingress Protection Test EquipmentIngress Protection Test Equipment

Ingress Protection Test EquipmentIngress Protection Test Equipment